A mint is achieved with a good crop and of course with a good drying and curing . Once harvested the second part is as important as the first. Depending on the drying and curing condicones can get a normal hiervita becomes something considerably better, or else make a beautiful buds something infumable.
Here go some basic notions to do with your grass once harvested.
Often the beginner grower believes enough dry grass in a few days and then start smoking. That’s a big mistake because one of the factors that will influence our tastes good buds and colocon will be the “time.” We know that when the plant is alive is not psychoactive, when dry it starts one chemical process by which the non-psychoactive THC its psychoactive form to its neutral form becomes acidic.And this process requires time among other things, in addition to good conditions of temperature and humidity. Later delve into these issues. Dry plant means eliminating excess water so he could smoke this. Read more about this in this article. This process must not be too fast because if so get that taste bad and scratch when smoked.Normal is dry in a dark, ventilated place. A very common problem especially here in the South is still too hot when we’re drying our plants so we have to be careful not too dry, becoming dust when grindamos.
Once dried (each grower decides when to end the process), keep the grass on the boats. I for one, hope that the splitting pequeñan twigs but these gorditas bend. This is an indication that the buds retain some moisture inside, but squeak out. Once dried preserved in sealed containers with idea of cure.
There are many urban legends as you have to cut the floor to dry, that if whole and face down, roots, etc without them. The truth is that however much we want once we cut the resin plant is already there and say how much the “upside down or delado” I will not go further. Typically the plant by cutting branches maturing second fence and hung upside down, for the simple reason that it is easier for the stem agarrala for the tip bud.
Drying means marijuana cure more slowly until this point searched for after humidity retained until use. Once the buds in the jars (the recommended sealing, are very easily in “all 100”), opened and closed these once a day with the idea that moisture left in the buds, now divided around the pot, eliminating the Let’s go until we get the point that we like.
likes Some rather dry. On the contrary I am looking to have a point of moisture so I was not too dry on the metal box that I use to remember that smoking will not forget that here in Malaga “ase musho stalled”.
Expect to wait at least three months before you start smoking our grass, so that the heart has had time to remove some of chlorophyll and curing has to do its effect. Over time the buds are taking a less-green, more yellow or brown in any of the cases. Symptom of that lost part of chlorophyll. The truth has nothing to view a “firecracker” of a grass with tradition, that is, who has had a few months of healing, one made with a newly cut grass. The first goes much smoother by the throat, its smoke besides having better flavor is far less toxic. We must reduce risks when smoking.
@8 months ago
Powdery mildew, Blanquilla, Blanqueta, Mal white, Mold, Ash, Oidiopsis, powdery mildew, Oidium …
The White Mal was a little-known fungus for cannacultivador @ s, this being the nightmare pear in many indoor and outdoor crops.
A fungus that creates a layer between grayish, whitish, fine dust covering buds, leaves and stems. Spread by the wind and it is advisable to spray with fungicide as a preventive potassium soap , but it appears we explain and propose you other options to combat it.
What you see:
The fungal spores are carried by the wind and fall on leaves, germinating and introducing a “rootlets” to absorb nutrients from the plant.
This fungus favors him very humid conditions around 70-80% and mild temperature. Disappears in midsummer, when the thermometer goes from 25 ° C to resurface in the fall. Liquid water required for their development, just excessive moisture for their development.
Powdery mildew fungus is an outside, is developed on the surface and does not penetrate the sheet is limited to the upper part, therefore, can be attacked with fungicides curatively, once it has infected.
In foreign attacks the weakest plants like those in gloomy areas or plants with much leaf mass and slightly over-nitrogen, meaning that care in wet areas with mineral fertilizers with very high proportions of nitrogen, use an organic fertilizer as vermicompost better in such areas. Indoor low lighting and stale air favor this disease. Find out more information here.
If is in your crop leaf mass cuts affected several more selective pruning, renewal and increases the movement of air and removes nitrogen from the diet of your plants, be grateful. This fungus requires cleaning the grow room and other infected plants outdoors can affect us.
With Powdery mildew can therefore act curatively although it is preferable to use preventive products to avoid the infection. If the plant is already infected and not be forced to go to specific fungicides
A vegetable concentrate 100% natural and that works really well is ceylymices , natural cinnamon extract also also kills mites ( spider mites ) and serves as a bio-nutrient by leaf. Tested for thousands of years ago, the Egyptians were using cinnamon extract with various functions.
Another natural fungicide is propolix hydroalcoholic solution propolis on natural product made by bees from resinous substance collected from the buds of trees, shrubs and smaller plants placed at the entrance of the hive, in order to seal all cracks and prevent the entry or presence of any parasites or disease.
Laboratory tests have proven effective bacteriostatic, bactericidal and fungicidal properties, other than anesthetic, anti-inflammatory and healing properties.
The mixture bio fungi cinnamon-thyme-propolis is also very effective in organic products and a pleasant smell!
Another well-known contact fungicide is sulfur which is a cheap and effective non-hatred that also acts against mites. Do not apply sulfur when the temperature is above 30 ° C because it would cause burns.
Plants should be sprayed with potassium soap every other week to prevent colonization of the fungus spore spread and avoid excess humidity culture.
Discard heavily infected plants if not be impossible to remove the fungus from your crop.
@8 months ago